Throttle body
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Throttle body › Throttle body
Fuel and emission control systemsThrottle body
THROTTLE BODY
Caution
• Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
Removal
- Remove the negative battery terminal.
- Remove the air pipe.
- Remove the accelerator cable from the throttle lever.
Note
• Before disconnecting the water hoses, drain the engine coolant.
- Disconnect the water hoses.
- Disconnect the connectors for the ISC valve and the throttle sensor.
- Remove the throttle body.
Inspection
- Verify that the throttle valve is fully closed.
- Verify that the throttle valve moves smoothly when the throttle lever is moved from fully closed to fully open.
- Replace the throttle body if necessary.
Caution
• Do not remove the thin seal coating from the throttle valve or bore.
Installation
Install in the reverse order of removal.
Note
• Use a new mounting gasket.
Tightening torque:
19—25 N·m (1.9—2.6 m·kg, 14—19 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Mazda touch up paint
- PARTPanel clip assortmentSearch: Mazda panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.