Igniter
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Igniter and High-Tension Lead › Igniter
Engine electrical systemIgniter
IGNITER
Inspection
- Disconnect the igniter connector.
Warning
• Do not ground the power connector terminal (Blue: 1-pin), the wiper 20A fuse will be burned.
- Connect the SST between the igniter and igniter connector as shown.
- Connect the SST to the power connector (Blue: 1-pin).
- Connect a voltmeter between the SST (brown wire) and a ground.
- Turn the ignition switch ON.
- Verify that there is approx. 12V at the terminal.
If not as specified, check related wiring.
Caution
• Do not activate the SW2 switch for more than 1 sec.
- Push the SW2 switch on the SST while observing the ohmmeter.
- Verify that the voltmeter indicates approx. 8V.
- If not as specified, replace the igniter.
- Disconnect the voltmeter from the brown wire and connect it to the SST gray wire.
- Repeat Steps 5 through 9.
HIGH-TENSION LEAD
Inspection
Use an ohmmeter to measure the resistance of each lead.
Resistance: 16 kΩ per 1 m (3.28 ft)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.