Ignition coil
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Ignition Coil › Ignition coil
IGNITION COIL
Inspection
- Disconnect the ignition coil connector.
- Check for voltage at the positive ( + ) terminal of the ignition coil connector with the ignition switch in the ON position.
Voltage: Approx. 12V
- If there is no voltage check the main fuse, ignition switch, and wire harness.
Primary coil winding
Measure resistance of the primary coil winding of each coil with an ohmmeter.
If not within specification, replace the coil.
Primary coil winding resistance (at 20°C [68°F]):
0.78—0.94Ω
Secondary coil winding
Measure resistance of the secondary coil winding of each coil with an ohmmeter.
If not within specification, replace the coil.
Secondary coil winding resistance (at 20°C [68°F]):
11.2—15.2 kΩ
Installation of Case
Use a 500V megger tester to measure the insulation resistance between the primary terminal and the coil case.
Resistance : 10 MΩ min.
Replacement
- Disconnect the high tension-leads and ignition coil connector.
- Remove the installaition bolts and the ignition coil.
- Install in the reverse order of removal.
Tightening torque:
19—25 N·m (1.9—2.6 m-kg, 14—19 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTSpark plugsSearch: Mazda MX-5 1990 spark plugs
- TOOLSpark plug socketSearch: spark plug socket
- TOOLSpark plug gap toolSearch: spark plug gap tool
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.