Ignition timing
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Ignition Timing › Ignition timing
Engine electrical systemIgnition timing
IGNITION TIMING
- Check the condition of the engine (spark plugs, leaks in hoses, etc.).
- Verify that all accessories are OFF.
- Warm up the engine to the normal operating temperature.
Note
- When using an externally powered timing light and/or tachometer connect it to the power connector (Blue: 1-pin).
Warning
- Do not ground the power connector terminal (Blue: 1-pin); the wiper 20A fuse will be burned.
- Connect a timing light and tachometer to the diagnosis connector terminal (IG–).
Caution
- Be extremely careful when making connections to the diagnosis connector as a mistaken connection will cause a malfunction.
- Connect the SST and set TEST SW to “SELF TEST” or connect diagnosis connector terminals (TEN) and (GND) with a jumper wire.
- Check the idle speed, and set it to specification if necessary.
Idle speed: 850 ± 50 rpm
- Check if the timing mark (Yellow) on the crankshaft pulley and the timing belt cover are aligned.
Ignition timing: 10° ± 1° BTDC (at idle)
- If the marks are not aligned, loosen the crank angle sensor lock bolt, and turn the crank angle sensor to make the adjustment.
- Tighten the crank angle sensor lock bolt to the specified torque.
Tightening torque:
19—25 N·m (1.9—2.6 m-kg, 14—19 ft-lb)
- After adjusting the ignition timing, disconnect the jumper wire or SST from the diagnosis connector.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.