Recharging
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Terminal and cable › Recharging
Engine electrical systemRecharging
- Clean and tighten the battery terminals and cables.
- Coat the terminals with grease.
- Inspect for corroded or frayed battery cables.
- Check the rubber protector on the positive terminal for proper coverage.
Recharging
| Battery | Slow charge (A) | Quick charge (A) |
|---|---|---|
| S46A24L(S) | Under 3 | Max. 20 |
Warning
- Before performing maintenance or recharging the battery, turn off all accessories and stop the engine.
- The negative battery cable must be removed first and installed last.
Caution
- Do not removed vent caps.
Follow carefully the instructions of the battery charger to prevent overcharging.
- Remove the battery cover.
- Disconnect the battery cables from the battery.
- Measure and record the voltage between the battery terminals.
- Decide the charging current and charging time by referring to the figure below.
- Charge the battery.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.