Air bleeding
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Air bleeding › Air bleeding
ClutchAir bleeding
AIR BLEEDING
The clutch hydraulic system must be bled to remove air introduced whenever a hydraulic line is disconnected.
Note
- The fluid in the reserve tank must be maintained at the 3/4 level or higher during air bleeding.
Caution
- Clutch fluid will damage a painted surface. If fluid does get on a painted surface, wipe it off immediately.
- Do not mix different brands of clutch fluid.
- Do not reuse the clutch fluid which was drained out.
- Remove the bleeder cap from the clutch release cylinder and attach a vinyl hose to the bleeder plug.
- Insert the other end of the vinyl hose in a clear container.
- Slowly pump the clutch pedal several times.
- While depressing the pedal, loosen the bleeder screw with the SST to let fluid and air escape. Close the bleeder screw with the SST.
- Repeat Steps 3 and 4 until no air bubbles are seen in the fluid.
- Tighten the bleeder screw.
Tightening torque:
5.9—8.8 N·m (60—90 cm-kg, 52—78 in-lb)
- Check for correct clutch operation.
- Verify that there is no fluid leakage.
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.