Disassembly Note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly and Assembly (H) › Disassembly Note
ClutchDisassembly Note
Disassembly Note
Snap ring
Note
- Do not damage the push rod contact surface of the piston.
Press down on the piston and remove the snap ring with snap-ring pliers.
Piston and secondary cup assembly
Caution
- Hold a rag over the master cylinder to prevent the piston and secondary cup assembly from jumping out.
Remove the piston and secondary cup assembly, spacer, and primary cup by applying compressed air through the clutch pipe installation hole.
Assembly Note
Caution
- Before assembly, make sure all parts are completely clean.
- Do not mix different brands of clutch fluid.
- Do not reuse the clutch fluid which was drained out.
- Apply the specified clutch fluid to the piston and secondary cup assembly, spacer, primary cup, and cylinder bore before assembly.
- Replace parts with new ones whenever specified to do so.
Piston and secondary cup assembly
Install the spring, primary cup, spacer, and piston and secondary cup assembly, noting the proper direction of the parts. (Refer to page H–10.)
Snap ring
Note
- Do not damage the push rod contact surface of the piston.
While pressing the piston, install the snap ring.
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.