Removal Note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- H Clutch › Removal Note
ClutchRemoval Note
Removal Note
Clutch cover and disc
- Install the SST.
- Loosen each bolt one turn at a time in a crisscross pattern until spring tension is released. Then remove the clutch cover and disc.
Flywheel
Note
- After removing the flywheel, inspect for oil leakage past the crankshaft rear oil seal. If necessary, replace the oil seal. (Refer to Section B.)
- Hold the flywheel with the SST.
- Remove the flywheel.
Pilot bearing
Remove the pilot bearing with the SST, if necessary.
Installation Note
Flywheel
- Wipe the bolts clean, and apply sealant to the bolt threads.
- Install the flywheel and SST.
- Tighten the bolts in the pattern shown.
Tightening torque:
96—103 N·m (9.8—10.5 m·kg, 71—76 ft-lb)
Pilot bearing
Note
- Install the pilot bearing flush with the flywheel.
Install the new bearing with a suitable pipe.
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.