Installation Note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Overhaul › Installation Note
ClutchInstallation Note
Installation Note
Clutch pipe
Tighten the clutch pipe with the SST.
13—22 N·m (1.3—2.2 m-kg, 9.4—16 ft-lb)
Air Bleeding
After installation, bleed the clutch system.
(Refer to page H–9.)
OVERHAUL
Caution
- Clean the disassembled parts in solvent and blow through all ports and passages with compressed air.
- Before assembly, make sure all parts are completely clean.
- Apply the specified clutch fluid to the piston and cup assembly and cylinder bore before assembly.
- Disassemble in the order shown in the figure, referring to Disassembly Note.
- Inspect all parts and repair or replace as necessary.
- Assemble in the reverse order of disassembly.
- Boot
- Push rod
- Piston and cup assembly
Disassembly
Note............. page H–13
Inspect for wear, scoring, and cracks - Spring
- Bleeder cap
- Bleeder screw
- Steel ball
- Release cylinder body
Inspect cylinder bore for scoring and corrosion
Disassembly Note
Piston and cup assembly
Caution
- Hold a rag over the release cylinder to prevent the piston and cup assembly from jumping out.
Remove the piston and cup assembly by applying compressed air through the clutch pipe installation hole.
Parts & tools for this job For 1990 Mazda MX-5
- PARTClutch kitSearch: Mazda MX-5 1990 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Mazda MX-5 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.