Caution
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Differential › Caution
Front and rear axlesCaution
DIFFERENTIAL MOUNTING SPACER
- Remove the differential mounting spacer.
05U0MX-070
- Turn a bolt (M14x1.5) into the sleeve.
- Twist and pull the bolt downward.
- Install a bolt (M6x1) into the hole in the block to hold the sleeve, and remove the long bolt (M14x1.5).
- Remove the bolt (M6x1).
05U0MX-071
Caution
- Do not remove the spacers shown in the figure from the PPF.
- If they are removed, repalce the PPF as an assembly.
- Remove the transmission-side bolts, and remove the PPF.
05U0MX-072
Driveshaft
Mark the driveshaft and output shaft for proper installation.
05U0MX-073
Differential
- Support the differential with a jack.
- Down and move it forward.
Note
- If it is difficult to separate the driveshaft from the output shaft, remove one side upper arm installation bolt and nut.
- Separate the driveshaft from the output shaft.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.