Installation note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Differential › Installation note
Front and rear axlesInstallation note
Note
- After removing the differential, support the transmission as follows to prevent damaging the fire wall, crank angle sensor, and engine mount.
- Prepare a steel plate as shown in the figure, a wooden block, bolts (8x1.25mm), and washers.
- Install the parts as shown in the figure.
Installation note
Differential
- Connect the driveshaft to the output shaft with the marks aligned.
- Install the differential.
Tightening torque:
Ⓐ 83—98 N·m (8.5—10 m·kg, 61—72 ft-lb)
Ⓑ 18—26 N·m (1.8—2.7 m·kg, 13—20 ft-lb)
Caution
- Adjust the rear wheel alignment after installation, if the upper arm installation bolt and nut are removed. (Refer to Section R.)
Power plant frame (PPF)
- Install the differential mounting spacer.
Tightening torque:
37—52 N·m (3.8—5.3 m·kg, 27—38 ft-lb)
- Support the transmission with a jack so that it is level.
- Position the PPF and snugly tighten the transmission-side bolts by hand.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.