Disassembly note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly (M) › Disassembly note
Front and rear axlesDisassembly note
Disassembly note
Boot bands
To remove the boot bands, pry up the locking clip with a screwdriver, then raise the end of the band.
Clip
Note
• Mark with paint; do not use a punch.
- Mark the driveshaft and outer ring for proper reassembly.
- Remove the clip.
Snap ring
Note
• Mark with paint; do not use a punch.
- Mark the driveshaft end and inner ring.
- Remove the snap ring with snap ring pliers.
Cage, inner ring, and balls
Disassemble in the following order:
- Insert a screwdriver between the inner ring and cage to remove the balls.
Note
• Mark with paint; do not use a punch.
- Mark the inner ring and cage.
- Turn the cage approximately 30°, then pull it away from the inner ring.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.