Overhaul
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Overhaul › Overhaul
Front and rear axlesOverhaul
Caution
- Secure the joint in a vise with protective material (such as copper plates) on the vise jaws.
- Be careful that dust or other foreign material does not enter the joint while the work is being performed.
- Do not disassemble the wheel-side ball joint.
- Do not wash the joint unless it is being disassembled.
- Disassemble in the order shown in the figure, referring to Disassembly Note.
- Inspect all parts and repair or replace as necessary.
- Assemble in the reverse order of disassembly, referring to Assembly Note.
- Boot bands
- Disassembly Note.................... page M–19
- Assembly Note ...................... page M–21
- Clip
- Disassembly Note.................... page M–19
- Outer ring
- Inspect inside bore for wear, corrosion, and scoring
- Snap ring
- Disassembly Note.................... page M–19
- Balls
- Disassembly Note.................... page M–19
- Assembly Note ...................... page M–20
- Inner ring
- Disassembly Note.................... page M–19
- Assembly Note ...................... page M–20
- Cage
- Disassembly Note.................... page M–19
- Assembly Note ...................... page M–20
- Boots
- Disassembly Note.................... page M–20
- Assembly Note ...................... page M–20
- Dust cover
- Shaft and ball joint assembly
- Inspect splines for damage and wear
- Inspect wheel-side joint for excessive play and rough rotation
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.