Installation note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Driveshaft › Installation note
Front and rear axlesInstallation note
Note
- If the driveshaft is stuck to the wheel hub, install a used locknut so that it is flush with the end of the shaft, and tap the nut with a plastic hammer.
Installation note
Driveshaft
Align the marks and install the driveshaft.
Tightening torque:
54—64 N·m (5.5—6.5 m-kg, 40—47 ft-lb)
Locknut
Install a new locknut and stake it.
Tightening torque:
216—294 N·m (22—30 m-kg, 159—217 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.