Double offset joint
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Driveshaft › Double offset joint
Front and rear axlesDouble offset joint
DOUBLE OFFSET JOINT
Inspection / Removal / Installation
- Inspect the driveshaft, referring to Inspection.
- Remove in the order shown in the figure, referring to Removal Note.
- Install in the reverse order of removal, referring to Installation Note.
After installation, adjust the rear wheel alignment. (Refer to Section R.)
- Rear wheel
- Locknut
Installation Note ........................ page M–17 - Driveshaft
Removal Note ............................ page M–16
Overhaul .................................. page M–18
Inspection
Driveshaft
- Check the dust boot on the driveshaft for cracks, damage, leaking grease, and a loose boot band.
- Check the driveshaft for bending, cracks, and wear of joints or splines.
- Repair or replace the driveshaft if necessary.
Removal note
Driveshaft
Before removing the driveshaft, mark the driveshaft and output shaft for proper installation.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.