Preparation sst
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Preparation sst › Preparation sst
Front and rear axlesPreparation sst
PREPARATION SST
| 49 0118 850C Puller, ball joint | For disconnection of tie-rod end and upper arm ball joint |
| 49 0727 575 Puller, ball joint | For disconnection of lower arm ball joint |
WHEEL HUB, STEERING KNUCKLE
Inspection / Removal / Installation
- Inspect wheel bearing play, referring to Inspection.
- Remove in the order shown in the figure, referring to Removal Note.
- Inspect all parts and repair or replace as necessary.
- Install in the reverse order of removal, referring to Installation Note.
- Front wheel
- Brake caliper assembly
Removal Note.................................... page M–6 - Hub cap
- Disc plate
- Locknut
Installation Note.............................. page M–7 - Front wheel hub assembly
Inspect for cracks and damage
Disassembly / Inspection /
Assembly ....................................... page M–8 - Tie-rod end
Removal Note.................................... page M–6
Service ........................................... Section N - Lower arm
Removal Note.................................... page M–6
Service ........................................... Section R - Upper arm
Removal Note.................................... page M–6
Service ........................................... Section R - Dust cover and knuckle spindle
Inspect dust cover for damage and distortion
Inspect knuckle spindle for cracks and damage
Parts & tools for this job For 1990 Mazda MX-5
- PARTFront wheel bearingSearch: Mazda MX-5 1990 front wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Mazda MX-5 1990 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.