Removal / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Removal / Installation › Removal / Installation
Steering systemRemoval / Installation
Caution
- Do not remove the steering wheel of air bag equipped models (U.S. spec.) if not necessary.
- Adjust the clockspring connector after installing the combination switch. (U.S. spec.) (Refer to Section T.)
- Disconnect the negative battery cable.
- Remove in the order shown in the figure, referring to Removal Note.
- Install in the reverse order of removal.
- Tighten all necessary nuts and bolts to the specified torque.
- After installation, check if the horn sounds. If the horn does not sound, remove the air bag module and connect the module connectors. (Refer to Section T.)
- Air bag module
Removal / Installation.................... Section T - Horn pad (without air bag)
- Locknut
- Steering wheel
Removal Note........................... page N–10 - Column cover
- Combination switch
Removal / Installation.................... Section T - Lower panel
- Intermediate shaft bolt
- Steering shaft
Disassembly / Inspection /
Assembly.................................. page N–10
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.