Brake fluid
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Brake Fluid and Brake Pedal › Brake fluid
Braking systemBrake fluid
BRAKE FLUID
Inspection
Check the fluid level in the reservoir. It should be between MAX and MIN.
If the fluid level is extremely low, check the brake system for leaks.
Fluid specification:
SAE J1703 or FMVSS 116, DOT-3
Caution
- The fluid in the reservoir must be maintained at 3/4 level or higher during bleeding.
- Do not allow the brake fluid to get on painted surfaces.
Replacement
- Remove the brake fluid from the reservoir with a suction pump.
- Fill the reservoir with clean brake fluid.
- Attach a vinyl tube to the bleeder screw and place the other end of the tube in a clear container.
- Pump out the old brake fluid by loosening the bleeder screws one by one and pumping the brake pedal until only clean fluid is expelled.
- Fill the reservoir to the specified level.
BRAKE PEDAL
On-vehicle Inspection
Pedal height
Check that the distance from the center of the upper surface of the pedal pad to the carpet is as specified.
Pedal height: 171—181mm (6.93—7.13 in) (With carpet)
Adjustment
- Disconnect the stoplight switch connector.
- Loosen locknut Ⓑ and turn switch Ⓐ until it does not contact the pedal.
- Loosen locknut Ⓓ and turn rod Ⓒ to adjust the height.
- Adjust the pedal free play and tighten operating rod locknut Ⓓ.
- Turn the stoplight switch until it contacts the pedal; then turn an additional 1/2 turn. Tighten the locknut.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
- TOOLBrake line flaring toolSearch: brake line flaring tool
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.