Proportioning bypass valve
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Proportioning bypass valve › Proportioning bypass valve
Braking systemProportioning bypass valve
PROPORTIONING BYPASS VALVE
Inspection
- Connect two pressure gauges [9,810 kPa (100 kg/cm², 1,422 psi)] to the pipes.
- Measure the fluid pressure from the master cylinder and to the rear brake.
Specification
| Fluid pressure kPa (kg/cm², psi) | |||
|---|---|---|---|
| A | A' | B | B' |
| 2,943 (30, 427) | 2,943 ± 196 (30 ± 2, 427 ± 28) | 6,867 (70, 995) | 4,120 ± 294 (42 ± 3, 597 ± 43) |
Caution
- If not as specified, replace the valve assembly.
- After inspection:
Add brake fluid and bleed the air.
(Refer to page P–6.)
Check the brake lines for fluid leakage.
Replacement
1. Remove in the order shown in the figure.
2. Install in the reverse order of removal.
3. After installation:
(1) Add brake fluid and bleed the air. (Refer to page P–6.)
(2) Check the brake lines for fluid leakage.
Caution
• Brake fluid will damage painted surfaces. If it does get on a painted surface, wipe it off immediately.
- Brake pipe
Removal................................page P–17
Installation..............................page P–17 - Bolt
- Proportioning bypass valve
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.