Caution
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Removal / Installation › Caution
Braking systemCaution
- Remove in the order shown in the figure.
- Install in the reverse order of removal.
- Take the following steps after installation:
- (1) Check and adjust the push rod and piston clearance. (Refer to page P–11.)
- (2) Add fluid and bleed the air. (Refer to page P–6.)
- (3) Check all parts for fluid leakage.
- (4) Make an on-vehicle check of the unit. (Refer to page P–13.)
- (5) Check that the vacuum hose does not contact other parts.
Caution
- Apply grease to the clevis pin.
Apply sealant to the gasket contact surface.
- Fluid level sensor connector
- Brake pipe
- Proportioning valve
- Master cylinder
- Vacuum hose with check valve
- Clevis pin
- Power brake unit
- Gasket
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Mazda MX-5
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.