Ball joint dust boot
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Ball joint dust boot › Ball joint dust boot
SuspensionBall joint dust boot
Removal note
Upper arm ball joint
Separate the upper arm ball joint from the knuckle with the SST.
Ball joint dust boot
Remove the dust boot with a chisel.
Caution
- Do not damage the ball joint stud.
Installation note
Ball joint dust boot
- Press the dust boot on with a 30mm (1 1/8 in) socket until the dust boot contacts the seat.
Caution
- Install the dust boot squarely and do not press excessively; the inner metal ring will be deformed if not done correctly.
- Verify that the clearance between the boot and the seat is less than 1mm (0.04 in).
- Shake the ball joint stud several times to make sure there is no grease leakage.
Inspection
Upper arm ball joint
Ball joint rotation torque
- Shake the ball joint stud 5 times.
- Connect the SST to the ball stud, and measure the rotation torque with a pull scale.
Rotation torque:
0.4—1.2 N·m (4—12 cm-kg, 3.5—10.0 in-lb)
Pull scale reading:
3.9—11.8 N (0.4—1.2 kg, 2.9—8.8 lb)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.