Removal / Inspection / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Stabilizer › Removal / Inspection / Installation
SuspensionRemoval / Inspection / Installation
Removal / Inspection / Installation
- Jack up the front of the vehicle and support it with safety stands.
- Remove the undercover.
- Remove in the order shown in the figure.
- Inspect all parts and repair or replace as necessary.
- Install in the reverse order of removal, referring to Installation Note.
- Tighten all nuts and bolts to the specified torques, referring to the figure.
Note
• Loosely tighten the stabilizer control link and bracket bolts. Lower the vehicle and tighten all nuts and bolts to the specified torques with the vehicle unladed.
- Stabilizer bracket
- Stabilizer bushing
Inspect for deterioration and wear
Installation Note ........................ below - Stabilizer
Inspect for bending and damage - Stabilizer control link
Inspect for bending and damage
Installation note
Stabilizer bushing
Align the bushing with the installation mark on the stabilizer.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.