Removal / Inspection / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Crossmember › Removal / Inspection / Installation
SuspensionRemoval / Inspection / Installation
Removal / Inspection / Installation
- Jack up the vehicle.
- Remove the wheels and the undercover.
- Support the engine with a hoist.
- Remove in the order shown in the figure.
- Inspect all parts and repair or replace as necessary.
Note
- Use a container or rags to collect the power steering fluid when disconnecting the power steering pipes.
- Lower the crossmember and other suspension parts as an assembly, and then separate the parts.
- Loosely tighten the stabilizer bracket, upper arm, and lower arm bolts when assembling before installation. Lower the vehicle and tighten all nuts and bolts to the specified torques with the vehicle unladed.
- Install in the reverse order of removal.
- Adjust the front wheel alignment. (Refer to page R–6.)
- Bleed the air from the brake system. (Refer to Section P.)
- Brake pipe
Removal / Installation.................... Section P - Pinion shaft bolt
Removal / Installation .................... Section N - Power steering pipe
Removal / Installation .................... Section N - Shock absorber bolt
- Front crossmember assembly
Inspect for damage - Stabilizer bracket
- Upper arm bolt
- Lower arm bolt
- Steering gear bracket bolt
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.