S Body (page 2 of 3)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- S Body
BodyS Body · page 2 of 3
Installation Note
Top fabric
- Remove the original double-sided adhesive tape from the front header.
- Degrease the front header with ethyl alcohol.
- Install new double-sided adhesive tape to the front header.
- Thread the cables into the top fabric.
- Place the link assembly over the top fabric.
- Roll the top fabric over the bow retainer.
- Hang the end of the top fabric on the bow retainer.
- Clamp the top fabric to the bow with protected water pump pliers.
- Affix the top fabric to the rear bow with the Velcro.
Note
• Install the top fabric to the bows, beginning from the rear bow. Perform Steps 6, 7, and 8.
Note
• Pull the top fabric by hand to verify that it is held securely.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Mazda touch up paint
- PARTPanel clip assortmentSearch: Mazda panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.