Rear window molding (Detachable hard top)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Rear window molding (Detachable hard top) › Rear window molding (Detachable hard top)
BodyRear window molding (Detachable hard top)
Rear window molding (Detachable hard top)
- Remove the rear window glass. (Refer to page S–42.)
- Install the rear window glass. (Refer to page S–42.)
- Apply primer with a brush to the bonding area of the new rear window molding, and allow it to dry for approx. 30 minutes.
Caution
- Keep the area free of dirt and grease. Do not touch the surface. If primer gets on the hand, remove it immediately.
- Install the rear window molding to the glass, as shown.
- If the molding is too long, cut the excess molding 10mm (0.39 in) inside the joint molding edge.
Hardening time of repair seal
| Temperature | Surface hardening time | Time required until car can be put into service |
|---|---|---|
| 5°C (41°F) | Approx. 1.5 hr | 12 hr |
| 20°C (68°F) | Approx. 1hr | 4 hr |
| 35°C (95°F) | Approx. 10 min | 2 hr |
- Check for water leaks. If a leak is found, wipe the water off well and repeat the installation.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Mazda touch up paint
- PARTPanel clip assortmentSearch: Mazda panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.