Horn
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Horn (Canada spec.) › Horn
Body electrical systemHorn
HORN
Canada spec.
- Remove the steering shaft.
- Check continuity between the horn conductor plate and the serration gear part.
| Horn switch | Continuity |
|---|---|
| ON | Yes |
| OFF | No |
- If not as specified, replace the horn switch and steering wheel as an assembly.
- If correct, repair wire (G/O) (Horn relay — horn switch).
Step 5
- Remove the knee protector.
- Disconnect the clock spring connector.
- Check continuity of the clock spring connector as shown in the figure.
| Continuity | Action |
|---|---|
| Yes | Repair wire (G/O) (Horn relay — Clock spring connector) |
| No | Replace combination switch assembly |
Warning
• After installation of the air bag module, verify that the air bag system is operating normally by monitoring the air bag warning lamp. (Refer to page T–138.)
Step 6
- Ground the terminal wire (G/O) of the horn relay connector.
- Measure the voltage at the following terminal wires of the horn relay connector.
| Wire | Voltage | Action |
|---|---|---|
| (G/W) Terminal A | 12V | Next check wire (G/W) of terminal D |
| 0V | Repair wire (G/W) (STOP 15A fuse — Horn relay) | |
| (G/W) Terminal D | 12V | Next check wire (G/R) |
| 0V | Repair wire (G/W) (STOP 15A fuse — Horn relay) | |
| (G/R) | 12V | Repair wire (G/R) (Horn relay — Horn) |
| 0V | Replace horn relay |
Parts & tools for this job For 1990 Mazda MX-5
- PARTReplacement bulbsSearch: Mazda MX-5 1990 bulbs
- TOOLDigital multimeterSearch: automotive digital multimeter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.