Step 1
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting › Step 1
Body electrical systemStep 1
Symptom: Horn does not sound.
Step 1
- Check the STOP 15A fuse.
- If the fuse is burned, replace it. Check and repair the wire harness, if necessary.
- If the fuse is OK, go to Step 2.
Step 2
- Disconnect the horn connector.
- Apply 12V to the horn, and check if the horn sounds.
- If the horn sounds, go to Step 3.
- If the horn does not sound, replace the horn.
Step 3
- Remove the knee protector.
- Ground the terminal wire (G/O) of the horn relay connector.
- If the horn sounds, go to Step 4.
- If the horn does not sound, go to Step 6.
Step 4
U.S. spec.
Warning
Before removal of the air bag module, the negative battery cable must be disconnected to prevent accidentally deployment.
- Remove the air bag module. (Refer to page T–150.)
- Check continuity between the terminal of the horn switch connector and the steering shaft.
| Horn switch | Continuity |
|---|---|
| ON | Yes |
| OFF | No |
- If not as specified, replace the horn switch and steering wheel as an assembly.
- If correct, go to Step 5.
Warning
After installing of the air bag module, verify that the air bag system is operating normally by monitoring the air bag warning lamp. (Refer to page T–138.)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.