Step 1
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting (5) › Step 1
Body electrical systemStep 1
Caution
• Before troubleshooting, read SERVICE PRECAUTION on page T–133.
Step 1
- Disconnect the negative battery cable.
- Remove the knee protector, and disconnect the clock spring connectors (Orange and blue).
- Disconnect the diagnostic module connector.
- Check continuity between terminal-wires of the diagnostic module connector.
| Terminal-wire | Continuity | Action |
|---|---|---|
| 2B (G/W)— 2D (G/W) | Yes | Go to Step 2 |
| No | Replace wire harness |
Step 2
- Disconnect the diagnostic connector.
- Check continuity between terminal-wire of diagnostic module connector and a body ground.
| Terminal-wire | Continuity | Action |
|---|---|---|
| 2C (G)— Body ground | Yes | Go to Step 3 |
| No | Go to Step 5 |
Step 3
- Disconnect the diagnostic module connectors.
- Check continuity between terminal-wires of the diagnostic module connector.
| Terminal-wire | Continuity | Action |
|---|---|---|
| 1H (G/B)— 2C (G) | Yes | Go to Step 5 |
| No | Go to Step 4 |
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.