Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)13 · Body and cab accessories
13 · Body & interior

Inspection procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Lighting Systems › Inspection procedure
Body and cab accessoriesInspection procedure · page 1 of 2
ACCESSORIES & BODY, CAB – Lighting Systems – figure
Fig. 15: Identifying Discharge Headlight System Terminal layout
Courtesy of MAZDA MOTORS CORP.

INSPECTION PROCEDURE

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

STEPINSPECTIONACTION
1INSPECT POWER SUPPLY CIRCUIT OF
DISCHARGE HEADLIGHT CONTROL
MODULE
• Disconnect the discharge headlight control module connector.
• Turn the headlight switch to the
HEADLIGHT (LO) position.
• Measure the voltage at discharge headlight control module terminal C (wiring harness- side).
• Is the voltage approx. 12 V ?
Yes Go to Step 6.
NoGo to the next step.
2INSPECT FUSE
• Turn the headlight switch to the OFF position.
• Remove the HEAD LOW R 15 A fuse (RH) or HEAD LOW L 15 A fuse (LH).
• Inspect the fuses.
• Are the fuses normal?
Yes Go to the next step.
NoReplace the fuse.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.