Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Boot assembly note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Drive Shaft › Boot assembly note
Driveline and axlesBoot assembly note
DRIVELINE/AXLES – Drive Shaft – figure
Fig. 14: Wrapping Shaft Spline With Vinyl Tape
Courtesy of MAZDA MOTORS CORP.
  1. Remove the boot.

BOOT ASSEMBLY NOTE

NOTE: The boot shapes on the axle side and the differential side are different so do not miss install them.

  1. Fill the inside of the new dust boot (wheel side) with grease.

NOTE: Do not touch the grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.

Grease amount

90-110 g {3.18-3.88 oz.}

  1. Install the boot with the drive shaft spline still wrapped with vinyl tape.
  2. Remove the vinyl tape.

TRIPOD JOINT, SNAP RING ASSEMBLY NOTE

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.