Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Boot disassembly note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Drive Shaft › Boot disassembly note
Driveline and axlesBoot disassembly note
DRIVELINE/AXLES – Drive Shaft – figure
Fig. 13: Removing Snap Ring Using Snap Ring Plier
Courtesy of MAZDA MOTORS CORP.
  1. Remove the tripod joint from the shaft.

CAUTION: To prevent damage to the component, do not use a hammer when removing it.

BOOT DISASSEMBLY NOTE

NOTE: Remove the axle side boot only if there is an abnormality.

  1. Wrap the shaft spline with vinyl tape.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.