Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Engine coolant level inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Cooling System › Engine coolant level inspection [lf]
EngineEngine coolant level inspection [lf]
  • When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.

ENGINE COOLANT LEVEL INSPECTION [LF]

WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system.

Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.

When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.

NOTE: If the "FL22" mark is shown on or near the cooling system cap, use FL22 type engine coolant.

FL22 type engine coolant is shipped as a diluted solution (55% coolant, 45% water). Use the solution as is when replacing coolant.

  1. Verify that the engine coolant level in the coolant reserve tank is between the L and F marks.
  2. If the engine coolant level is below L mark, add engine coolant.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.