Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Engine coolant leakage inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Cooling System › Engine coolant leakage inspection [lf]
EngineEngine coolant leakage inspection [lf]
  1. Start the engine and warm up the engine by idling.
  2. After the engine warms up, perform the following steps. At this time, be careful of the coolant temperature to prevent overheating.
  3. Run the engine at approx. 2,500 rpm for 5 min .
  4. Run the engine at approx. 3,000 rpm for 5s , then idle.
  5. Repeat step 2 4-5 times.
  6. Stop the engine, and inspect the coolant level after the coolant temperature decreases. If it is low, repeat steps 7 thru 10.
  7. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [LF] .)

ENGINE COOLANT LEAKAGE INSPECTION [LF]

WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system.

Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.

When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.

  1. Inspect the engine coolant level. (See ENGINE COOLANT LEVEL INSPECTION [LF] .)
  2. Remove the cooling system cap.
  3. Clean the installation parts of the cooling system cap.
  4. Install the SST and a radiator cap tester to the coolant reserve tank filler port.
  5. Apply pressure using the radiator cap tester.

CAUTION: Applying more than 122.6 kPa {1.25 kgf/cm2 , 17.8 psi} can damage the hoses, fittings, and other components, and cause leakage.

Pressure

122.6 kPa {1.25 kgf/cm2 , 17.8 psi} [1 min]

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.