Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Engine coolant capacity (approx. quantity) (page 3 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Cooling System
EngineEngine coolant capacity (approx. quantity) · page 3 of 3
ENGINE – Cooling System – figure
Fig. 7: Identifying Radiator Drain Plug
Courtesy of MAZDA MOTORS CORP.

ANTIFREEZE SOLUTION MIXTURE PERCENTAGE (EXCEPT FL22 TYPE ENGINE COOLANT)

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

Engine coolant protection Volume percentage (%) Gravity at 20°C {68°F}
WaterCoolant
Above -16°C {3°F}65351.057
Above -26°C {-15°F}55451.072
Above -40°C {-40°F}45551.086
  1. Refill the coolant into the coolant reserve tank up to the F mark on the tank.
  2. Install the cooling system cap.

CAUTION: If the water temperature gauge rises too high, stop the engine and decrease the water temperature to prevent overheating. Then, verify the malfunctioning part and repair or replace it.

If the engine coolant level in the coolant reserve tank is below the L mark during engine coolant air bleeding operation, stop the engine, and after the engine coolant temperature decreases, add engine coolant. Then, resume the engine coolant air bleeding operation.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.