Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Spark plug inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Ignition System › Spark plug inspection [lf]
EngineSpark plug inspection [lf]

CAUTION: If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing.

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF] .)
  4. Remove the front suspension tower bar (joint). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  5. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [LF] .)
  6. Remove the spark plugs using a plug-wrench.
  7. Install in the reverse order of removal.

Tightening torque

10-14 N.m {1.1-1.4 kgf.m. 8-10 ft.lbf}

SPARK PLUG INSPECTION [LF]

SPECIFICATION

Spark plug type

L3G2 18 110, L3Y1 18 110

PLUG GAP INSPECTION

CAUTION: To avoid possible damage to the tip, do not adjust the plug gap.

To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap.

  1. Measure the spark plug gap using a wire type plug gap gauge.
    • If it exceeds the specification, replace the spark plug.

Spark plug gap

1.25-1.35 mm {0.050-0.053 in}

CLEANING

CAUTION: Carbon may adhere to the tip of the spark plug during vehicle delivery or repeated short distance driving during the winter time. If

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.