Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Visual inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Ignition System › Visual inspection
EngineVisual inspection

there is any malfunction such as rough idling or start difficulty due to carbon adhesion causing plug fouling, burn off the carbon by performing no-load racing of the engine.

  • When performing the no-load racing, apply the side brake and foot brake, move the shift lever to neutral (MT), or the selector lever to P position (AT) to prevent an accident and serious injury.
  • To avoid possible damage to the spark plug tip, do not use a wire brush for cleaning.

NOTE: To avoid possible damage to the tip, use gasoline to clean the spark plugs after removing dirt.

If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction.

Do not perform no-load racing at high engine speed continuously for 10s or more.

  1. If there is carbon adhering to the spark plug, perform no-load racing at 4,000 rpm for 2 min, 2 times .

VISUAL INSPECTION

  1. Inspect the following items:
    • If any of the following malfunction are indicated, replace the spark plug.
    • Insulator breakage
    • Worn electrode
    • Damaged gasket
    • Badly burned insulator (sparking side)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.