Alignment (Pre-Alignment Inspection): Service and Repair
- Make
- Mazda
- Model
- Protege
- Engine
- L4-1.5L DOHC
- Year
- 1995
- Section
- Alignment › Service and Repair › Pre-Alignment Inspection
MaintenancePre-Alignment Inspection · page 1 of 3
Alignment: Service and Repair
Pre-Alignment Inspection
1. Ensure tire pressure is as specified by manufacturer.
2. Inspect ball joints and steering linkage for excessive looseness. Repair as required.
3. Ensure vehicle is level and has no luggage or passenger load.
4. Ensure difference in height from center of wheel to fender brim between right and left sides does not exceed 0.39 inch.
5. Jounce vehicle prior to any measurement in order to allow suspension components to settle.
Pinch or Ctrl + scroll to zoom. Double-tap to reset.
Parts & tools for this job For 1995 Mazda Protege 1.5L
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.