Eclipse L4-1996cc 2.0L DOHC (1995)
With the door closed and the window rolled completely up, use a pencil to mark on the tape the current position of the window molding at the glass.
Then open the door and measure the distance from the edge of the glass to the mark on the tape. Record the measurements on the tape.
Specifications are:
^
Front tape: 1.5 to 4.5 mm
^
Rear tape: 2.5 to 4.5 mm
If out of specification, height adjustment is required.
4.
Wet the inner corner of the glass. Close the door just until the glass contacts the weatherstrip. Measure the gap between the body and the door, just
below the door handle. Specification is 15 to 20 mm.
If out of specification, tilt adjustment is required.
Symptom Chart
SYMPTOM CHART