Eclipse L4-1996cc 2.0L DOHC (1995)
1.
Use the chart and the measurements taken on the previous pages of this bulletin to determine possible glass adjustments required to correct glass
misalignment.
2.
Perform adjustments in the order they are numbered in the chart.
3.
Make the appropriate glass adjustment(s) as described in the ADJUSTMENT PROCEDURES section of this bulletin.
4.
Always make the final adjustments described in the ADJUSTMENT PROCEDURES section last.
EXAMPLE: If there is a gap at the top front or rear of the glass, perform parallelism, fore and aft, height and final adjustments in that order.
Adjustment Procedures
ADJUSTMENT PROCEDURES
IMPORTANT
Always make adjustments in small increments.
After making adjustments, always re-measure to determine if glass position is at proper specifications.
Refer to pages 42-35 to 42-38 of the 1995 Eclipse service manual for adjustment details.
PRELIMINARY STEPS
1.
Always first check the door-to-body alignment. With the door glass in the full down position, check the door latch-to-door striker alignment. If
necessary, adjust the door striker.
2.
Remove the door panel. Remove the window switch assembly from the door panel, then reconnect it so that you can operate the door glass with
the switch.
A. PARALLELISM ADJUSTMENT