Eclipse V6-3.8L (6G75) (2006)
d.
Select "Memory Card Transfer".
When the memory card data transfer is complete, remove the memory card from the laptop and install it in the VCI. Then go to Step 7 for CAN-FLASH
VEHICLES ONLY or Step 8 FOR K-LINE FLASH VEHICLES.
7.
CAN-FLASH VEHICLES ONLY:
IMPORTANT:
DO NOT DISCONNECT THE MEDIC-II LAPTOP. DO NOT USE VCI STANDALONE REPROGRAMMING.
The following equipment is required for PCM reprogramming on CAN-Flash vehicles:
^
MEDIC-II PC
^
Reprogramming Database on DVD-ROM (Reflash Update CD 8106 or later for this concern)
^
VCI (Vehicle Communication Interface) - MB991824
^
MUT-III main harness A (blue) - MB991910
^
USB 2.0 cable - MB991827
^
"Engine Compartment/Control Module" labels - p/n MSSF-024G-00
Connect this equipment in the same manner as for normal vehicle diagnosis. When reprogramming a CAN-Flash vehicle, the VCI and MEDIC-II laptop
must be connected. DO NOT use VCI Standalone on CAN-Flash vehicles.
a.
In the MUT-III System Select menu, click on the car symbol at the bottom of the screen.
b.
Connect the VCI to the vehicle. DO NOT DISCONNECT THE LAPTOP.