Lancer Evolution L4-2.0L DOHC Turbo (2003)
Q: Are ETACS-ECU connector C-226 in good condition?
YES: Go to Step 7.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the rear wiper operates normally, it indicates that a
correct auto-stop signal is sent from the rear wiper motor.
STEP 8.
Check the wiring harness between rear wiper motor connector F-05 (terminal 3) and ETACS-ECU connector C-226 (terminal 17).
NOTE: Also check junction block connector C-217 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector C-217 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear wiper motor connector F-05 (terminal 3) and ETACS-ECU connector C-226 (terminal 17) in good condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear
wiper motor.
Inspection Procedure H-3