Gear Components (Cont'd) - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › Gear Components (Cont'd) - Nissan 180SX S13 Workshop Manual
Gear Components (Cont'd)
| ASSEMBLY |
Gear Components (Cont'd)
c. Install steel ball and 1st gear washer.
@ Apply multi-purpose grease to steel ball and 1st gear
washer before installing.
| i
i ' i SMT403A
6. Install mainshaft and counter gear on adapter plate and main drive gear on mainshaft.
a. Press mainshaft assembly to adapter plate with Tool.
KV31100401
TM433
b. Press counter gear into adapter plate with Tool.
c. Install 3rd main gear and then press 3rd & 4th synchronizer assembly.
@ Pay attention to direction of 3rd & 4th synchronizer.
a ~ _—- f N
~ Shifting insert
“-. Spread spring Rear side
d. Install thrust washer on mainshaft and secure it with mainshaft front snap ring. Select proper snap ring to minimize clearance of groove in mainshaft. Allowable clearance of groove: 0 - 6.18 mm (0 - 0.0071 in) Mainshaft front snap ring: Refer to $.D.S.
e. Apply gear oil to mainshaft pilot bearing and install it on mainshaft.
MT-20
Parts & tools for this job For Nissan 180SX
- PARTClutch kitSearch: Nissan 180SX clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Nissan 180SX manual gearbox oil
As an Amazon Associate we earn from qualifying purchases.