Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual20 · PD prop shaft & diff carrier
20 · General

adjusting | SE - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › adjusting | SE - Nissan 180SX S13 Workshop Manual
PD prop shaft & diff carrieradjusting | SE - Nissan 180SX S13 Workshop Manual

adjusting | SE

ASSEMBLY - Differential Carrier (Cont'd)

5. Set drive pinion assembly (as shown in figure at left) in Drive pinion differential carrier and install drive pinion, with press and suitable tool. Pinion bearing Wel Stop when drive pinion touches bearing.

adjusting | SE

Apply multi-purpose grease to pinion rear bearing inner race, pinion front bearing inner race and front pilot bearing.

: Pinion front bearing inner race Kes SPD8S7 =

Q —— spacer \ \\ sPD896 \\

6. Apply multi-purpose grease to cavity at sealing lips of oil seal. install front oil seal with Tool. Tool number: KV38106500

SPOSS7

7. Install companion flange, and tighten pinion nut to specified (w) torque with Tool. ort er Ascertain that threaded portion of drive pinion and pinion nut are free from oil or grease. Tool number: ST38060002 Tool —4

i. PD416

8. Turn drive pinion in both directions several times, and measure pinion bearing preload. Pinion bearing preload:

1.4 -1.4 N-m (11 - 14 kg-cm, 9.5 - 12.2 in-Ib) When pinion bearing preload is outside the specifications, replace pinion bearing adjusting washer and spacer with a different thickness.

sPO8B4 i PD-26

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.