Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual20 · PD prop shaft & diff carrier
20 · General

oY I _ oes - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › oY I _ oes - Nissan 180SX S13 Workshop Manual
PD prop shaft & diff carrieroY I _ oes - Nissan 180SX S13 Workshop Manual

oY I _ oes

ASSEMBLY

Differential Case Measure clearance between side gear thrust washer and

1. differential case. Clearance between side gear thrust washer and differential case (A - B):

0.15 - 0.20 mm (0.0059 - 0.0079 in) The clearance can be adjusted with side gear thrust washer. Refer to $.D.S.

2. Apply oil to gear tooth surfaces and thrust surfaces and check that they turn properly.

Install differential case LH. and R.H.

3.

4 Place differential case on ring gear.

5. Apply locking sealant to ring gear bolts, and install them. Tighten bolts in a criss-cross fashion, lightly tapping bolt head with a hammer.

oY I _ oes

6. Press-fit side bearing inner cones on differential case with Tool. Tool number: @® KV38100300 @® $1T33061000

PD353 PD-24

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.