DOOR CONTROL - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › DOOR CONTROL - Nissan 200SX S12 Workshop Manual
DOOR CONTROL
DOOR CONTROL
‘Control Cable and Rod Adjustment (Cont'd)
WATER COCK CONTROL ROD
TEMP. CONTROL CABLE
¢ Whon adjusting water cock control rod, first * Clamp the cable while pushing cable outer case disconnect temperature control cable from ai and air mix door lever in direction of arrow. mix door lever and then adjust control rod. Reconnect temperatura control cable and re- adjust it.
1. Push air mix door lever in direction of arrow. 2, Pull control rod of water cock in direction of arrow $0 as to make clearance of about 2 mm (0,08 in) between ends of rod and link lever and connect the rod to door lever.
—~
MAX, COLD position RHAd9e 2mm (0.08 ia)
INTAKE DOOR CONTROL CABLE
1, Move link lever in direction of arrow.
2. Connect the rod to door lever while pushing door lever in direction of arrow. RHAGBO
3. Clamp the cable while pushing cable outer
case in direction of arrow.
Control rod: ee
en Link levue
AN Aes
HA-5
Parts & tools for this job For Nissan 200SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.