Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual18 · HA - Heater & Air Conditioner
18 · General

PRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › PRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 200SX S12 Workshop Manual
HA - Heater & Air ConditionerPRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 200SX S12 Workshop Manual

PRECAUTIONS FOR REFRIGERANT CONNECTION

PRECAUTIONS FOR REFRIGERANT CONNECTION

Do not apply O-ring:

WARNING: compressor oil Anply Gradually loosen discharge side hose fitting, and re- comprettor oil move it after remaining pressure has been released. When replacing of cleaning refrigerant cycle com.

ponents, observe the foltowin

© Do not eave compressor on its side or upside ai 3 down for mare than 10 minutes, as compressor z a oil will enter tow pressure chamber. © When connecting tubes, be sure to use # torque prayent Inflated portion wrench, -Toraue wrench SHABSTA @ After inserting tube to union until O-ring i no longer visible, tighten nut to specified rorqu

SHAgaBA After disconnecting tubes, plug all openings im- © mediately to prevent entrance of dirt and mois- ture.

q

Plug sHAgse © Always repiace used O-rings. ‘* When connecting tube, apply compressor oil to portions shown in illustration. Be careful not to apply oil to threaded portion. O-ring must be closely attached to inflated por After connecting line, conduct leak test a tion of tube. make sure that there is no leakage from conr tions. When the gas leaking point is found, di connect that line and replace the O-ring. Check fit for further use and then tighten connectio to seal seat for the specified torque.

HA-16

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.