Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual19 · No. 1 Bow
19 · General

ADJUSTMENT, CLAMP LATCH - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ADJUSTMENT, CLAMP LATCH - Nissan 240SX 1991-1992 Workshop Manual
No. 1 BowADJUSTMENT, CLAMP LATCH - Nissan 240SX 1991-1992 Workshop Manual

ADJUSTMENT, CLAMP LATCH

NO. 1 BOW 14-3

ADJUSTMENT, CLAMP LATCH

Adjustment of the clamp latch determines the sealing quality of the No. 1 bow to the windshield header and latching or releasing effort of the clamp mechanism. See = A “long” clamp latch adjustment can be identified by low latching effort or the No. 1 bow setting too high off the windshield header. <—— This condition can cause wind noise and water leaks. Short adjustment

A “short” clamp latch adjustment will cause excessively high latching effort and No. 1 bow to “sink” below the windshield header when latched. This condition may Cause weatherstrip damage or clamp latch failure. = Use the following procedure to adjust the clamp latch.

Long adjustment

NOTE: If for any reason a clamp latch is in need of Front egde of No. 1 bow, adjustment, both sides of the vehicle should be

oe to 2mm below header

checked and, if necessary, adjusted.

1. _ Raise convertible top and secure to windshield header. (a) Note latch operation and latching effort. (b) Latching effort should be equal on both sides.

2. Check No. 1 bow-to-header fit. (a) No. 1 bow should be flush to 2mm below windshield he trim. (b) Check other side of vehicle.

3. Adjust clamp latch. (a) Raise convertible top off windshield header. (b) Loosen clamp latch set screw.

(c) Turn clamp latch in desired direction.

(d) Raise convertible top and check clamp latch adjustraent. (e) Lower convertible top and tighten clamp latch set screw. Torque: 10 Nm (88 in. Ib.) artediates (f) Repeat on other side of vehicle.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.