Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual19 · No. 1 Bow
19 · General

No. 1 Bow - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › No. 1 Bow - Nissan 240SX 1991-1992 Workshop Manual
No. 1 BowNo. 1 Bow - Nissan 240SX 1991-1992 Workshop Manual

No. 1 Bow

NO. 1 BOW

14-5

CLAMP ASSEMBLY (cont'd)

2.

REMOVE CLAMP BODY.

(a) Using a 3mm punch, remove knurled pin from clamp body. (b) Remove torsion spring and two (2) bushings.

3.

REMOVE BUSHING FROM CLAMP ASSEMBLY SCREW.

ASSEMBLE

1.

INSTALL BUSHING TO CLAMP ASSEMBLY SCREW.

2.

INSTALL CLAMP BODY.

(a) Position torsion spring, two (2) bushings and clamp body to clamp assembly pivot.

NOTE: Position spring ends into two (2) holes provided in clamp body (b) Press knurled pin into clamp body.

3.

INSTALL CLAMP LATCH.

Thread clamp latch into clamp body to “measured length” when removed.

NOTE: Clamp latch curve (hook) must face forward when latch is installed.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.