405 L4-1905cc 1.9L (1989)
-
Remove dashboard mounting bolts (18) and (19)
-
Remove bolt (20) behind heater-A/C control panel
-
Remove strut (21) secured at (22) to the lower part of the dash and at (23) to the gear shift support
-
Clear away the speedometer cable, instrument cluster harness, and heater-A/C control panel
-
Protect the console with a fender cover
-
Remove the dashboard
-
Position the dashboard on a bench so that the back side is facing toward you and angled up
-
Remove the glove box light
-
Remove the glove box mounting screws, located as follows:
-
one phillips-head screw inside the glove box
-
two phillips-head screws on the left side (driver side) of the glove box (do not lose the metal bracket between the glove box and
dashboard)
-
two phillips-head screws along the top edge (one is immediately above the striker, the other at the top right corner)
-
Remove the single 10 mm bolt from the lower right (passenger side) corner of the tubular glove box support frame
-
The glove box and support frame can now be removed from the dash as a unit by sliding it down and to the rear
-
Reinstall components in the reverse order of disassembly
-
Ensure that non-return washers (24) are in position on locating dowels before refitting dashboard to firewall
-
Torque steering wheel nut to 22 ft.lbs.
WARRANTY INFORMATION:
This repair will be accepted when perfomed within the New Vehicle Limited Warranty period of three (3) years and/or 36,000 miles, whichever occurs
first.
Damage Code:
8214S5
Operation Number:
82050A
Time Allowance:
0550 hours