Liner protrusion (page 4 of 11)

Fit the liner seals, the thickness of which have just been determined, fig. I.

Carefully fold the tags (1) on the seal into the locating remove.

Position the identification tabs (2) so that they are perpendicular to flat (a).

Place the liners in their respective locations as shown in fig. II, positioning the identification tabs (2) as shown in the illustration.

Compress liners 3 and 4, fig. III, using tool 8.0128.

Measure the liner protrusion, above the cylinder block, at four points, fig. IV.

The highest point should be in the region of 0.14 mm.

Measure the maximum height difference between any two adjacent liners, fig. V.

• the height difference should not exceed 0.04 mm.

If the difference is greater than 0.04 mm.

• Replace the liner seal on the highest of the liners.

Reverse the position of toll 8.0128.

Repeat these reading on liners 1 and 2.

Lock the liners, in fig. VI using clamps 8.0132 A1Z.